Omega ILD44-UTP User Manual download pdf (Page 18)

PART 3

OPERATION: Configuration Mode

3.1 Introduction

The instrument has two different modes of operation. The first, Run Mode, is

used to display values for the Process Variable, and to display or clear Peak

and Valley values. The other mode, Menu Configuration Mode, is used to

navigate through the menu options and configure the controller. Part 3 of this

manual will explain the Menu Configuration Mode. For your instrument to

operate properly, the user must first "program" or configure the menu options.

Turning your Controller On for the First Time

The device becomes active as soon as it is connected to a power source. It

has no On or Off switch. The device at first momentarily shows the software

version number, followed by reset

RST

, and then proceeds to the Run Mode.

Table 3.1 Button Function in Configuration Mode

• To enter the Menu, the user must first press

button.

• Use this button to advance/navigate to the next menu item. The user can

navigate through all the top level menus by pressing

• While a parameter is being modified, press

to escape without saving

the parameter.

• Press the up

button to scroll through “flashing” selections. When a

numerical value is displayed press this key to increase value of a

parameter that is currently being modified.

• Holding the

button down for approximately 3 seconds will speed up the

rate at which the set point value increments.

• In the Run Mode press

causes the display to flash the PEAK value –

press again to return to the Run Mode.

• Press the down

button to go back to a previous Top Level Menu item.

• Press this button twice to reset the controller to the Run Mode.

• When a numerical value is flashing (except set point value) press

scroll digits from left to right allowing the user to select the desired digit to

modify.

• When a setpoint value is displayed press

to decrease value of a

setpoint that is currently being modified. Holding the

button down for

approximately 3 seconds will speed up the rate at which the setpoint

value is decremented.

• In the Run Mode press c causes the display to flash the VALLEY value –

press again to return to the Run Mode.

• Press the enter d button to access the submenus from a Top Level

Menu item.

• Press d to store a submenu selection or after entering a value — the

display will flash a

STRD

message to confirm your selection.

• To reset flashing Peak or Valley press d.

• In the Run Mode, press d twice to enable Standby Mode with

flashing

STBY

Reset: Except for Alarms, modifying any settings of the menu configuration

will reset the instrument prior to resuming Run Mode.

(UP)

(DOWN)

ENTER

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 70 71

Comments to this Manuals

No comments

Omega ILD44-UTP User Manual Page 18

Comments to this Manuals

Related products and manuals for Thermometers Omega ILD44-UTP