Omega TX82B User Manual download pdf (Page 9)

3.3 INSTALLATION/REMOVAL

The TX82B is housed in a 1/8 DIN case. The electronic circuitry can be installed or

removed from the front and is attached to the case with two M4 screws through the

rear panel.

Panel Mounting

1. Remove the two thumbnuts on the rear of the case.

2. Slide the sleeve off the case (see Figure 3-1 Exploded View).

3. Verify the panel cutout dimensions in Figure 3-2 Case Dimensions. Insert the

case in the panel cutout from the front and slide the sleeve on from the rear.

Install the two thumbnuts to secure the sleeve to the case.

Main Board Access:

1. Case must be removed from sleeve.

2. Remove lens from case.

3. Slide main board from front of case.

Figure 3-1 Exploded View (includes rear panel)

SLEEVE

THUMBNUT

CONFIGURATION LABEL

(BACK SIDE OF DISPLAY BOARD)

THREADED STUD

REAR PANEL

MAIN BOARD

DISPLAY

BOARD

FRONT LENS

ELECTROSTATIC RISK

DO NOT RUN OR

CLEAN WITH SOLVENT

J3 B

REAR CONNECTOR (P3)

FOR SIGNAL INPUT

1 2 3

ID. LABEL

CASE

PANEL

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Omega TX82B User Manual Page 9