Omega OFS30 User Manual download pdf (Page 6)

Operating Procedure

Left - Right Middle Bowl Switches:

Each switch corresponds to the number and location of the bowls config-

uration to the dispenser. When the switch is in the up/on position the motor

and cooling will be turned on.

Care and Cleaning

Preparing Product

Attention: Make sure that the mixture has a 13% - 15% minimum Brix (sugar

content). A lower concentrate could seriously damage the mixing parts,

as well as the gear motors. NEVER USE ONLY WATER.

1. If using product concentrate (instead of ready-to-use product), dilute

and mix the product with water, according to the directions given by the

manufacturer, in a separate container. Never pour dry powder, crystals, or

concentrate into a dry bowl.

2. Remove the merchandising lid. Pour the prepared product into the

bowl. Do not spill any material on lid or on bowl. There is a minimum and

maximum fill line on the bowl. Do not overfill or run the unit without

enough product. Running unit with product below the minimum full line

may cause damage to the unit. Insert the plug into a dedicated electrical

outlet.

Dispensing

Product

To dispense the product, position the cup

under the dispensing valve and lower the

dispensing lever.

NOTE: If the machine is turned off at night, with the bowls filled, or just partially filled, a layer of

solid ice may form on the surface due to the natural separation of the unmixed (non-moving)

product. In this case, before turning the machine back on, remove the layer of superficial ice

to prevent damage to the spiral agitator.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Omega OFS30 User Manual Page 6